Product Overview
his is the StrangeWatersPrints Metal Slip Trip Extender for the V2/V3 (newer, lighter) Slip Trips.
These are primarily intended to be used with Lee Sporting trigger housings.
Due to a design difference with the LS housings, some users have found their Safetys damaged by the Slip Trip especially when using the older version of the Slip Trip that weigh in excess of 1oz. This product was created to protect the SS lever from accelerated wear and damage caused by the Slip Trip making excessive contact with Safety when the bolt closes.
It also provides additional felt recoil reduction due to the extender spring acting as a secondary recoil buffer.
The Slip Trip Extender includes spring and a mini recoil buffer spacer which replaces the longer recoil buffer needed to prevent hammer override (recoil buffer spacer may be needed with full size & reverse stretch only - not needed with K).
2 sizes are available for either the heavier V1M slip trip or the updated lightweight V2M/V3M versions. This product listing is for the V2/V3 Slip Trips
Printed in Polymaker PA12-CF and annealed.
INSTRUCTIONS: Please refer to images below for installation. Be sure to apply plenty of lube to the extender, spring, and the insides of the receiver.
DISCLAIMER: Unfortunately the extender appears to have a fitment issue with PTRs with the pic rail welded to the receiver, along with other variants if there are large weld bumps inside the receiver. If you have a PTR with the pic rail welded to the receiver or any other variants with large weld bumps or obstructions the extender may cause the bolt to bind up and won't work properly. File the weld bumps down at your own risk.
